SOLID REMOVE UNEEDED TOPOLOGY

Up

Command

SOLID_REMOVE_UNEEDED_TOPOLOGY [<solid number>]

Remove un-needed topology from a solid.

Parameters

<solid number>

Solid number

If a solid number is not given, use selected solid(s).

Note: removing topology may change the solid number. If you are modifying one solid (by specifying a solid number) you can check the variable SolidRef to get the number of the solid after removing topology.

Example

SOLID_REMOVE_UNEEDED_TOPOLOGY 14  ! remove un-needed topology from solid 14

SOLID_REMOVE_UNEEDED_TOPOLOGY  ! remove un-needed topology from all selected solids