SOLID REMOVE UNEEDED TOPOLOGY
From Macros Wiki
Command
- SOLID_REMOVE_UNEEDED_TOPOLOGY [<solid number>]
- Remove un-needed topology from a solid.
Parameters
- <solid number>
- Solid number
If a solid number is not given, use selected solid(s).
Note: removing topology may change the solid number. If you are modifying one solid (by specifying a solid number) you can check the variable SolidRef to get the number of the solid after removing topology.
Example
- SOLID_REMOVE_UNEEDED_TOPOLOGY 14 ! remove un-needed topology from solid 14
- SOLID_REMOVE_UNEEDED_TOPOLOGY ! remove un-needed topology from all selected solids
