POINT ROTATE
From Macros Wiki
Command
- POINT_ROTATE <point number>, <xc>, <yc>, <angle>,
This is used to rotate a point about a circle.
Parameters
- <point number>
- The number of a previously defined macro point.
- <xc>
- X co-ordinate of the center point.
- <yc>
- Y co-ordinate of the center point.
- <angle>
- angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
Example
- - POINT_ROTATE 15, 12, 4, 16
