HOLEFR GET HOLE Variables
From Macros Wiki
Variables set by HOLEFR_GET_HOLE command
| HOLEFR Variable | Description | Description |
| HoleFrSelected | Number (0=not selected, 1=is selected) | Is the hole selected |
| HoleFrType | Number (from 1=simple to 9=compound) | Hole type |
| HoleFrRefType | Number (1=from solid, 2=from geometry) | How was the hole created |
| HoleFrGeoRef | Number | If hole came from geometry, the geometry reference number |
| HoleFrGeoWG | Number | If hole came from geometry, the geometry workgroup number |
| HoleFrSolRef | Number | If hole came from a solid, the solid number |
| HoleFrWP | Number | Geometry or solid workpiece |
| HoleFrEndCond | Number (1 to 5) | End condition (blind/thru/thru blind/obstructed/spherical) |
| HoleFrUnits | Number (0=metric, 1=inch) | Hole units |
| HoleFrNumSegments | Number | Number of hole segments |
| HoleFrTopClear | Number | Top Clearance Amount |
| HoleFrBottomClear | Number | Bottom Clearance Amount |
| HoleFrTipAngle | Number | Tip Angle |
| HoleFrAxisX | Number | Hole axis vector measured from top to bottom |
| HoleFrAxisY | Number | |
| HoleFrAxisZ | Number | |
| HoleFrPosTopX | Number | Hole Position measured at the top of hole |
| HoleFrPosTopY | Number | |
| HoleFrPosTopZ | Number | |
| HoleFrPosBottomX | Number | Hole Position measured at the bottom of hole |
| HoleFrPosBottomY | Number | |
| HoleFrPosBottomZ | Number |
