POINT 2P
From Macros Wiki
Command
- POINT_2P <point number>, <point>, <point>,
This is used to create a point between 2 other points.
Parameters
- <point number>
- The number of the point (1 to 100) to be defined. This is a number used by the macro to create other geometry.
- <line>
- This refers to a previously defined point (1 to 100), this should be given in the format P(Number).
- <circle>
- This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
Example
- - POINT_2P 2, 6, 2
