CIRCLE CP
From Macros Wiki
Command
- CIRCLE_CP <circle number>, <point>, <point>
This command is used to create a circle where 2 points lie on the circle, to define a radius of the circle, see CIRCLE_2P.
Parameters
- <circle number>
- The number of the circle (1 to 100) to be defined.This is a number used by the macro to create other geometry.
- <point>
- This refers to a previously defined point (1 to 100), this should be given in the format P(Number).
- <point>
- This refers to a previously defined point (1 to 100), this should be given in the format P(Number).
Example
- - CIRCLE_CP 3, 6
