LINE PA: Difference between revisions

Revision as of 16:24, 16 July 2010

LINE_HP <line number>, <point>, <angle>

This is used to create a line on a point int he direction of a given angle.

<line number>: The number of a previously defined macro line.
<point>: The number of an existing point.
<angle>: angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Use the DEGREES or RADIANS commands to switch between the two angle modes.

- LINE_PA 6, 2, 74

- LINE_PA 2, 9, -13

@@ Line 2: / Line 2: @@
 |description=This is used to create a line on a point int he direction of a given angle.
-|param1=<line number>|param1_desc= The number of the line (1 to 100) to be defined. This is a number used by the macro to create other geometry.
+|param1=<line number>|param1_desc= {{line number}}
-|param2=<point>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format P(Number).
+|param2=<point>|param2_desc= {{point}}
-|param3=<angle>|param3_desc= An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
+|param3=<angle>|param3_desc= {{angle}}
-:Use the DEGREES or RADIANS commands to switch between the two angle modes.
 }}