LINE CA: Difference between revisions

Revision as of 16:22, 16 July 2010

LINE_CA <line number>, <circle>, <angle>, <option>

This is used to create a line that is tangent to a circle at a given degrees, the option changes which side the line is on the circle.

<line number>: The number of a previously defined macro line.
<circle>: The number of an existing circle.
<angle>: angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Use the DEGREES or RADIANS commands to switch between the two angle modes.
<option>: Template:Option

- LINE_CA 4, 2, 63, 2

@@ Line 2: / Line 2: @@
 |description=This is used to create a line that is tangent to a circle at a given degrees, the option changes which side the line is on the circle.
-|param1=<line number>|param1_desc= The number of the line (1 to 100) to be defined. This is a number used by the macro to create other geometry.
+|param1=<line number>|param1_desc= {{line number}}
-|param2=<circle>|param2_desc= This refers to a previously defined point (1 to 100), this should be given in the format C(number).
+|param2=<circle>|param2_desc= {{circle}}
-|param3=<angle>|param3_desc= An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
+|param3=<angle>|param3_desc= {{angle}}
-:Use the DEGREES or RADIANS commands to switch between the two angle modes.
+|param4=<option>|param4_desc= {{option}}
-|param4=<option>|param4_desc= a value of 1 or 2 for choosing different options when creating objects
 }}