LINE LD: Difference between revisions
From Macros Wiki
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Command|syntax=LINE_LD < | {{Command|syntax=LINE_LD <line number>, <line>, <distance>, | ||
|description=This is used to create a line parallel to a line on the right or left at a certain distance. | |description=This is used to create a line parallel to a line on the right or left at a certain distance. | ||
Revision as of 21:03, 14 July 2010
Command
- LINE_LD <line number>, <line>, <distance>,
This is used to create a line parallel to a line on the right or left at a certain distance.
Parameters
- <line number>
- The number of the line (1 to 100) to be defined. This is a number used by the macro to create other geometry.
- <line>
- This refers to a previously defined point (1 to 100), this should be given in the format P1, L8, C25.
- <distance>
- The value of the distance in inches or mm, depending on what it is set to (inches are default)
In this case if the distance is a positive value the new line will be to the left of the old line, if it is negative it will be to the right of the old line.
Example
- - LINE_LD 21, 3, 4
- - LINE_LD 18, 7, -8
