POINT ROTATE: Difference between revisions
From Macros Wiki
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Command|syntax=POINT_ROTATE <point number>, <xc>, <yc>, <angle> | {{Command|syntax=[[Image:point_rotate.png|right|POINT_ROTATE]]POINT_ROTATE <point number>, <xc>, <yc>, <angle> | ||
|description= | |description=:Rotate a point about defined co-ordinates and a defined angle. | ||
|param1=<point number>|param1_desc= {{point number}} | |param1=<point number>|param1_desc= {{point number}} | ||
| Line 10: | Line 10: | ||
===Example=== | ===Example=== | ||
: | :POINT_ROTATE 15, 12, 4, 16 | ||
[[Category:Geometry]] | [[Category:Geometry]] | ||
Revision as of 18:27, 21 July 2010
Command
POINT_ROTATE
- Rotate a point about defined co-ordinates and a defined angle.
Parameters
- <point number>
- The number of a previously defined macro point.
- <xc>
- X co-ordinate of the center point.
- <yc>
- Y co-ordinate of the center point.
- <angle>
- angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
Example
- POINT_ROTATE 15, 12, 4, 16
