POINT CA: Difference between revisions
From Macros Wiki
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Command|syntax=POINT_CA < | {{Command|syntax=POINT_CA <point number>, <circle>, <angle>, | ||
|description=This is used to create a point on a circle at a certain angle from the center. | |description=This is used to create a point on a circle at a certain angle from the center. | ||
Revision as of 21:00, 14 July 2010
Command
- POINT_CA <point number>, <circle>, <angle>,
This is used to create a point on a circle at a certain angle from the center.
Parameters
- <point number>
- The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
- <circle>
- This refers to a previously defined point (1 to 100), this should be given in the format C(Number).
- <angle>
- An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.
Use the DEGREES or RADIANS commands to switch between the two angle modes.
Example
- - POINT_LC 15, 12, 4
