POINT ROTATE: Difference between revisions

Latest revision as of 23:02, 2 August 2010

POINT_ROTATE <point number>, <xc>, <yc>, <angle>

Rotate a point about defined co-ordinates and a defined angle.

<point number>: The number of a previously defined macro point.
<xc>: X co-ordinate of the center point.
<yc>: Y co-ordinate of the center point.
<angle>: angle value, either degrees or radians. Positive angles indicate a CCW direction, negative for CW.

Use the DEGREES or RADIANS commands to switch between the two angle modes.

POINT_ROTATE 1, 1, 1, 65

@@ Line 1: / Line 1: @@
-{{Command|syntax=POINT_ROTATE <point number>, <xc>, <yc>, <angle>,
+[[Geometry:Creating_Geometry|{{Up}}]]
-|description=This is used to rotate a point about a circle.
-|param1=<point number>|param1_desc=  The number of the point (1 to 100) to be defined.This is a number used by the macro to create other geometry.
+{{Command|syntax=[[Image:point_rotate.png|right|POINT_ROTATE]]POINT_ROTATE <point number>, <xc>, <yc>, <angle>
-|param2=<xc>|param2_desc= The value of the center of the circle for the x axis.
+|description=:Rotate a [[macro_point|point]] about defined co-ordinates and a defined angle.
-|param3=<yc>|param3_desc= The value of the center of the circle for the y axis.
-|param4=<angle>|param4_desc= An angle value can be in either degrees or radians. Positive angles indicate a CCW direction, negative for CW.<br/>Use the [[DEGREES]] or [[RADIANS]] commands to switch between the two angle modes.
+|param1=<point number>|param1_desc=  {{point number}}
+|param2=<xc>|param2_desc= {{xc}}
+|param3=<yc>|param3_desc= {{yc}}
+|param4=<angle>|param4_desc= {{angle}}
 }}
 ===Example===
-:- POINT_ROTATE 15, 12, 4, 16
+:POINT_ROTATE 1, 1, 1, 65
 [[Category:Geometry]]